Compaq Netelligent 3024 User Manual page 61

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
A-4 Installing the Management Daughterboard
3. Remove the six chassis screws (shown in Figure A-2) with a Phillips
screwdriver.
Chassis Screws
(Phillips Head)
Figure A-2. Removing the Repeater Cover
4. Remove the four expansion port screws (two per port) with a Phillips
screwdriver. These screws are shown in Figure A-2. When all the screws are
out, remove the chassis cover by sliding it toward the back of the repeater.
5. Remove the two serial port screws from the repeater's faceplate(shown in
Figure A-3). Also remove the serial port shield.
Serial Port
Shield Screws
(Phillips Head)
Serial
Port
MEDIA EXPANSION
PORT
Figure A-3. Serial Port Screws
6. Insert and tighten the two hex standoff screws into the repeater's
Collision 1
Mode 1
1 2 3 4 5 6 7
SEGMENT 1
motherboard as shown in Figure A-4.
Collision 2
Mode 2
8 9 10 11 12 13 14 15
SEGMENT 2
EXPANSION PORTS
IN OUT
Expansion Port Screws
(Phillips Head)
Collision 3
Mode 3
16 17 18 19 20 21 22 23
SEGMENT 3
Chassis Screws
(Phillips Head)
24
UPLINK
PORT 24