Using The Aui Media Option; Using The Fiber Media Option - Compaq Netelligent 3024 User Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-4 Media Connection Options
3. Insert the BNC media connector board, firmly connecting the 20-pin

Using the AUI Media Option

Use the AUI media connector (Part Number 267063-001) to connect the
repeater to a Thicknet backbone. To install the AUI connector:
1. Remove the two screws from the media connector faceplate and
2. Insert the AUI media connector board, firmly connecting the 20- pin
3. Tighten the faceplate screws.
NOTE: There are no jumper settings for this optional board.

Using the Fiber Media Option

Use the fiber media connector (Part Number 267065-001) to connect the
repeater to a FOIRL backbone. To install the fiber connector:
1. Remove the two screws from the media connector faceplate and
2. Insert the AUI media connector board, firmly connecting the 20-pin
3. Tighten the faceplate screws.
NOTE: There are no jumper settings for this optional board.
male connector to the repeater's motherboard and tighten the faceplate
screws.
carefully pull out the factory installed UTP module board.
male connector to the repeater's motherboard.
carefully pull out the factory-installed UTP module board.
male connector to the repeater's motherboard.
WARNING: Observing the transmitter output power (port) on the fiber
module under magnification may cause injury to the eye. When viewed with
the unaided eye, the infrared output is radiologically safe. However, when
viewed under magnification, precaution should be taken to avoid exceeding
the limits recommended in ANSI Z136.1-1981.