Connecting Power - Compaq Netelligent 2524 User Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Connecting Power

Follow these steps to connect the repeater to power:
1. Plug the power cord into the power cord connector on the back of the
repeater. (In this example, a 2624 repeater is shown.)
Figure 3-9. Connecting Power
2. Insert the three-pronged plug on the power cord into a non-switched,
grounded power source that is near the repeater and easily accessible.
When you plug in the power cord, the repeater performs a power-on self test
(POST), which lasts approximately 1 minute. After a successful POST, the
LEDs indicate the current operating status. See the "LED Indicators" section in
Chapter 1, "Overview" for more information about the LED status.
If the POST fails, the STATUS LED flashes yellow. If this occurs, disconnect
the repeater from power and then reconnect power. If the problem continues,
contact Compaq Technical Support.
WARNING: Plugging in the power cord applies power to the repeater.
There is no ON/OFF switch on the repeater.
Netelligent 2524/2624 and 3512/3612 100Base-T Repeater User Guide
3-11