Connecting Power - Compaq Netelligent 1016 User Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-4 Setting Up the Repeater
2. To remove a bracket from the repeater, pull the bracket forward until it

Connecting Power

To connect the repeater to power, follow these steps:
1. Plug the female IEC connector of the power cord into the power cord
2. Insert the three-pronged plug on the power cord into an appropriate
When you plug in the power cord, all LEDs on the front panel are momentarily
ON, which confirms the repeater is operating correctly.
IMPORTANT: The repeater has no power switch. It receives power via the power
cord connection.
Disconnecting the Repeater from the
Power Source
Should you need to power down the repeater, you will need to properly
disconnect it from the power source. To power down the repeater, remove the
plug from the grounded power source (such as the wall outlet or power strip)
and not from the outlet on the back of the unit. The female plug on the power
cord is not a certified disconnect.
unsnaps from the plastic ridge inside the mounting slot.
outlet on the back of the repeater.
power source as shown in Figure 3-2 (see also the Caution under
"Electrical Requirements" in the section "Selecting a Location" in this
chapter). The power source should be near the repeater and easily
accessible (within the 6-foot, 1.8-meter, cord distance).