Compaq Netelligent 3024 User Manual page 63

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
A-6 Installing the Management Daughterboard
9. Insert the DB-9 connector (attached to the management daughterboard
10. From the front side of the faceplate, insert the to hex jack screws
11. Re-attach the repeater's chassis cover with the six chassis screws
12. Screw in the four expansion port screws removed in Step 4.
13. Reconnect the media expansion cable(s) if applicable.
14. Plug the power cord into the power connector on the back of the
15. Insert the three-pronged plug on the power module cable into an easily
NOTE: For pluggable equipment, the power outlet must be installed near the
equipment and must be easily accessible.
The management daughterboard upgrade is now complete.
via a ribbon cable) through the back side of the faceplate until it
protrudes through the front.
through the serial port holes. Place the washers over the screws from
the back side of the faceplate and tighten them with a hex jack
screwdriver.
removed in Step 3.
repeater. The lip on the power connector faces the top of the repeater.
accessible, grounded power outlet on the wall, a powerstrip, or a
grounded extension cord.