Configuring Extended Distance For Utp Wiring - Compaq Netelligent 3024 User Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-2 Media Connection Options
Configuring Extended Distance for UTP
Wiring
To set the extended distance on the UTP connector board, follow these steps:
1. Remove the two screws from the media connector faceplate and
2. Set the AW1 jumpers as shown in the figure below.
Figure 2-2. Extended Distance Jumper AW1
3. Replace the UTP media connector board, firmly connecting the 20- pin
carefully pull out the board.
AW1
male connector to the repeater's motherboard and tighten the faceplate
screws.
EXT
NORM
AW1
Standard
Extended
UTP Distance
(default)