. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-4
Installing the Repeater
2. Remove the Smart Uplink port cover plate from the 2624 or 3512/3612
repeater's front panel.
3. Insert the Smart Uplink module through the port hole, aligning the sides
of the SUM with the card guides inside the repeater (Figure 3-4).
Figure 3-4. SUM Installation
4. Carefully push the Smart Uplink module's 50-pin male connector into the
SUM socket on the repeater motherboard until the SUM is firmly seated
and its faceplate is flush with the repeater's front panel.
5. Secure the SUM to the repeater by tightening the SUM's spring screws.
CAUTION: Do not tighten the Smart Uplink Module's spring screws until
completing Step 4 of this procedure. If you tighten the spring screws before
the SUM is properly seated in the socket, you may damage the repeater.