Table of Contents
Advertisement
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1-7
LED Indicators
The repeater has several LED indicators to help you monitor and manage the
repeater. Table 1-1 describes the repeater LEDs.
Model 2524/2624 LEDs
The LEDs on the left side of the front panel indicate the collision status, power
supply, and general status of the repeater. The LEDs above each RJ-45 port
indicate activity on those ports. When you power on a managing 2624 repeater,
it performs a power-on self test (POST). The POST lasts approximately 1
minute. After the POST, all LEDs automatically change to their operational
modes.
Model 3512/3612 LEDs
The LEDs on the left side of the front panel indicate the status of both power
supplies (PWR A/main and PWR B/redundant) and the general repeater status.
The LEDs on the right side of the front panel show the collision status of the
repeater and the current backplane selection (1, 2, or 3). The LEDs above each
RJ-45 port indicates activity on those ports.
When you power on the managing 3612 repeater, it performs a power-on self
test (POST). The POST lasts approximately 1 minute, depending on the amount
of DRAM installed in the repeater (see Appendix C "Upgrading the DRAM").
After the POST, all LEDs automatically change to their operational modes.
Netelligent 2524/2624 and 3512/3612 100Base-T Repeater User Guide
Advertisement
Table of Contents
