Description - Hilti TE 30-A36 Operating Instructions Manual

Obligation signs
Wear eye Wear a hard
en
protection hat
Wear
breathing
protection
Symbols
Forward / Read the
reverse operating
instructions
before use
Hammer Chiseling
drilling

2. Description

2.1 Use of the product as directed
The power tool is a cordless combihammer with a pneumatic hammering mechanism.
The power tool is intended for drilling in concrete, masonry, metal and wood. The power tool can also be used
for light to medium-duty chiseling work on masonry and for surface finishing on concrete.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
To avoid hazards, only use the batteries and battery chargers recommended by Hilti for this power tool.
Do not use the battery as a power source for other unspecified appliances.
The power tool may be used only in a dry environment.
Do not use the power tool where there is a risk of fire or explosion.
Nationally applicable industrial safety regulations must be observed.
The working environment may be as follows: construction site, workshop, renovation, conversion or new
construction.
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The
power tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or
when used not as directed.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
2
Revolutions
per minute
Wear ear Wear
protection protective
gloves
Diameter
Location of identification data on the power tool
The type designation can be found on the type iden-
tification plate and the serial number on the side of
the motor housing. Make a note of this data in your
Return waste Drilling
material for without
operating instructions and always refer to it when
recycling. hammering
making an enquiry to your Hilti representative or
service department.
Type:
Generation: 02
Chisel position Revolutions
adjustment per minute
Serial no.:
Millimeters Direct current
Volts Rated speed Watts
Amps
Hertz