Page 1
TE 30-A36 Bedienungsanleitung Operating instructions Mode d’emploi Istruzioni d’uso Manual de instrucciones Manual de instruções Gebruiksaanwijzing Οδηγιες χρησεως Használati utasítás Instrukcja obsługi Инструкция по зксплуатации Návod k obsluze Návod na obsluhu Upute za uporabu Navodila za uporabo Kulllanma Talimatı IНСТРУКЦIЯ З ЕКСПЛУАТАЦIЇ...
In these operating instructions, the designation “the power tool” always refers to the TE 30-A36 combihammer Always keep these operating instructions to- gether with the power tool. Components, operating controls and indicators 1...
Make a note of this data in your operating in- structions and always refer to it when making an enquiry to your Hilti representative or service department. Forward / Drilling...
Page 8
e) Do not overreach. Keep proper footing and bal- d) Under abusive conditions, liquid may be ejected ance at all times. This enables better control of the from the battery; avoid contact. If contact acci- dentally occurs, flush with water. If liquid contacts power tool in unexpected situations.
To avoid hazards, use only the batteries and battery chargers recommended by Hilti for this power tool. Do not use the battery as a power source for other unspecified appliances.
Operating instructions NOTE Accessories can be found at your Hilti Center or online at www.hilti.com. 3.4 Additional items required for operating the tool A suitable battery of the specified type (see table in the Technical Data section) and a suitable battery charger from the C 4⁄36 series.
NOTE The vibration emission level given in this information sheet has been measured in accordance with a standardized test given in EN 60745 and may be used to compare one tool with another. It may be used for a preliminary assessment of exposure.
"Chisel adjustment". CAUTION The use of unsuitable grease may cause damage to the NOTE tool. Only use genuine grease from Hilti. When chiseling, please select forward rotation. 6.1.3 Removing the insert tool 7 6.2.4 Active Torque Control 11...
11 The power tool or the battery Electrical fault. Switch the power tool off immedi- gets very warm. ately, remove the battery from the tool and allow it to cool down while keeping an eye on it, contact Hilti Service.
Batteries that have reached the end of their life must be disposed of in accordance with national regulations or returned to Hilti. Most of the materials from which Hilti power tools or appliances are manufactured can be recycled. The materials must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking back your old power tools or appliances for recycling.
11 EC declaration of conformity (original) Hilti Corporation, Feldkircherstrasse 100, Designation: Cordless combihammer FL‑9494 Schaan Type: TE 30-A36 Generation: Year of design: 2012 We declare, on our sole responsibility, that this product Paolo Luccini Jan Doongaji complies with the following directives and standards:...