Description - Hilti SF 151-A Operating Instructions Manual

1.2 Explanation of the pictograms and other
information
Warning signs
en
General Warning:
warning electricity
Obligation signs
Wear eye Wear a hard
protection. hat.
Wear
breathing
protection.
Symbols
Read the Return waste
operating material for
instructions recycling.
before use.

2. Description

2.1 Use of the product as directed
The SF 151-A is a hand-held, cordless drill/driver for
driving and removing screws and for drilling in steel,
wood and masonry.
The SFH 151-A is a hand-held, cordless hammer
drill/driver for driving and removing screws, for
drilling in steel, wood and masonry and for ham-
mer drilling in concrete and masonry.
Working on materials hazardous to the health (e.g.
asbestos) is not permissible.
Do not use the battery as a power source for other
unspecified appliances.
Changes or modifications to the tool are not permiss-
ible.
14
Nominal speed
under no load
1 These numbers refer to the corresponding illustra-
Warning: hot Warning:
tions. The illustrations can be found on the fold-out
surface caustic
cover pages. Keep these pages open while studying
substances
the operating instructions.
In these operating instructions, the SF 151‑A cordless
drill/driver or SFH 151‑A cordless hammer drill/driver
with battery fitted, are referred to as "the tool".
Location of identification data on the tool
Wear ear Wear
The type designation can be found on the type plate
protection. protective
and the serial number on the side of the motor
gloves.
housing. Make a note of this data in your operating
instructions and always refer to it when making an
enquiry to your Hilti representative or service depart-
ment.
Volts Direct current
To avoid the risk of injury, use only genuine Hilti
accessories and insert tools.
Observe the information printed in the operating in-
structions concerning operation, care and mainten-
ance.
The tool is designed for professional use and may
be operated, serviced and maintained by trained, au-
thorized personnel. This personnel must be informed
of any special hazards that may be encountered. The
tool and its ancillary equipment may present haz-
ards when used incorrectly by untrained personnel or
when used not as directed.
Revolutions
per minute
Type :
Serial no.:
Hammer Drilling
drilling without
hammering