HP iPAQ h6315 Networking Manual page 35

Managing wireless networks
Viewing or editing a network
To view or edit an existing or available wireless network, perform the following steps:
1. Turn on the WLAN.
2. In the Connectivity pop-up box, tap Settings > Advanced tab > Network Card > Wireless tab. In
the Wireless networks box, tap name of the desired network to review or edit. Or on the Today
screen tap Settings > Connections tab > Connections icon > Advanced > Network Card. Tap the
network desired to review or edit.
3. If edits are made to the existing settings, then tap OK to save the new settings.
Deleting a network
To delete a wireless network, perform the following steps:
1. Turn on the WLAN.
2. In the Connectivity pop-up box, tap Settings > Advanced tab > Network Card >Wireless tab.
3. In the Wireless networks box tap the name of the desired network, holding down the stylus for a
few seconds until the Connect/Remove Settings drop-down box appears. Tap Remove Settings.
Or on the Today screen tap Settings > Connections tab > Connections icon > Advanced >
Network Card. Give the connection a name; tap the Wireless tab, highlight the desired
connection to delete, and hold the stylus down a few seconds until the drop-down box appears.
4. Tap Remove Settings.
Monitoring signal strength and status
Perform the following steps to view the signal strength between the HP iPAQ Pocket PC h5400 series
Microsoft Pocket PC 2003 ROM upgrade handheld device and the access point WLAN connection:
Note: The signal strength icon will only display when a connection is present.
1. Tap the Connectivity icon (
network the HP iPAQ is connected to (Work or Internet). Displayed next to the network type
(either Internet or Work) is the Wireless Card field, followed by some vertical green bars. Four
bars display the strongest connection signal.
Figure 7. The WLAN signal strength indicator for the HP iPAQ Pocket PC h5400 series with Microsoft Pocket PC 2003 ROM
upgrade
2. To make changes to the connection, tap Settings.
3. To exit the Connectivity box, tap the Hide button.
) in the Start bar. The Connectivity box displays the type of
or
35