Table Of Contents - Agilent Technologies QuickSwap G3185B Installation And Setup

Agilent G3185B QuickSwap Accessory
Installation and Startup
Installation
In This Manual 4
Kit Contents 5
Tools Required 5
Plumbing the Purge Gas 6
Update Auxiliary EPC Controller Firmware 11
Important Information 15
Before You Begin 16
Overview 16
1. Confirm that the GC and MSD are Ready for QuickSwap 18
2. Select and Install a Restrictor 19
3. Attach QuickSwap to the MSD Transfer Line 20
4. Connect the QuickSwap Tubing to the Purge Gas Tubing 23
5. Turn on the MSD and Begin Pumpdown 23
6. Start the MSD ChemStation and Load a Checkout Method 23
7. Set and Apply the Purge Gas Pressure 24
8. Confirm that the Actual Pressure Matches the Setpoint 24
9. Prepare the QuickSwap End of the Column 25
10. Connect the Column to the Inlet and QuickSwap 28
11. Configure the Column 28
12. Set and Apply the Column Flow 29
13. Recheck the QuickSwap Pressure 30
14. Perform an Initial Leak Test 30
15. When MSD Pumpdown is Finished, Autotune the MSD 30
16. Perform Final Leak Test using the MSD Manual Tune Screen 31
17. Retune the MSD 37
18. Run Samples 37
Agilent Technologies 3