Nikon Super CoolScan 9000ED Repair Manual page 27

Holder motor unit
・ Put #143 and #145 on the motor base plate (#B141), and put #144 on the gear base plate (#B142). Then apply the grease
(G940501) on the periphery of the larger gear.
・ Attach #B142 to #B141 with 2 screws (#190).
#B141
Note: For this part, NEVER
apply the grease.
・ Attach the holder motor (#511) on the motor base plate (#B141) with 2 screws (#190).
Position by turning counterclockwise and attach them with 2 screws (#190).
・ Attach the holder motor unit on the stage carriage unit with 3 screws (#194).
（Assemble them by pulling in the direction indicated by the arrow for positioning.）
・ Connect the cable of the holder motor (#511) to the connector of the relay FPC (#507).
Holder motor unit
Stage carriage unit
#B142
#144
#145
Grease: G940501
#143
#190×2
#511
- A14 ･
#190×2
#B141
#194×3
-
LS-9000
VRA51701-R.3607.A
#B142
#507
Cable of #511