Disassembly
Notes:
① Be sure to remove the power wire before disassembly.
② When disassembling, make sure to memorize the processing state of wires and FPCs, screws to be fixed
and their types, etc.
③ Because ICs are easily damaged by static electricity, be sure to get yourself earthed/grounded when
holding the main PCB and FPCs.
External cover
・Take out 8 screws at the back (#192) and 10 screws at the bottom (#192), then remove the side cover by sliding it.
(Removing 2 rubbers (#36) is unnecessary except when they are replaced.)
・Remove the rear panel (#32) by taking out 3 screws (#192) and 2 screws (#188). The connector shield-plate (#46)
comes off accordingly.
・Remove the connector on the main PCB A-part (which is connected from the front cover).
・Uncover the front cover by taking out 4 screws (#192).
Main PCB A-part
#36×2
#36
Front cover
- D1 ・
x2
#192×10
#192
x10
#192×4
#192
x4
I C
E
-
LS-9000
VRA51701-R.3607.A
#192×8
#192
x8
#31
#31
#188×2
#188
x2
#46
#46
#32
#32
#192×3
#192
x3