How to use Inspection Software
1. Purpose
This software is used when LS-9000ED is disassembled or its parts are replaced or inspections are made.
2. Preparation (tools required)
・DOS/V PC
・IEEE1394 board ( Use the product of package as it is. )
・IEEE1394 cable ( Use the product of package as it is. )
・Glass chart for adjustment and inspection(J61190)
・Positive film chart(J61189); Insert this into FH-835M
・IR pass filter (J63088); Insert this into FH-835M
・LS-9000ED inspection software (J65049A: Japanese, J65049B: English)
・Holder FH-835M ( Use the product of package as it is. )
【Hardware requirements】
・Windows2000
・Japanese/English OS
・CPU Pentium700MHz or more
・RAM 512MB or more
3. Inspection details
* Initialization
・Check the firmware version.
* Illumination irregularity
・Check for the raw data of the CCD with shading OFF in the standard range.
* Shading
・Check for the read-in data of the CCD waveform with shading ON in the standard range.
* Noise inspection
・By performing prescanning operation, check if the operating sound has no problem.
* Mechanical precision
・ Scanning position accuracy
Get the central position (average values of x, y) of each alignment mark at 4 positions, then comparing them with set
values, check the deviation of image scanning position (shading).
- A28 ・
-
LS-9000
VRA51701-R.3607.A