Nikon Super CoolScan 9000ED Repair Manual page 26

・ Pass 2 guide shafts (#123) through the hole of the stage carriage unit.
・ Slide the guide shaft (#123) of A side from side to side until the bearing fits smoothly.
・ Apply the grease (SUMITEC331) on the guide shaft (#123) of B side.
・ Assemble the stage carriage unit into the base, and fix 2 guide shafts (#123) with 4 retaining springs (#104) and 4 screws
(#194) at 4 positions.
・ Connect the screw shaft housing unit and the stage carriage unit with 2 screws (#191).
#194×4
#104×4
・ Connect the relay FPC (#507) to the connector of the sensor PCB (#506).
#507
Ａ
Slide from side to side
#123
Ｂ
Approx. 60 mm
Apply the grease (SUMITEC331) on the broken line.
#191 × 2
- A13 ･
Bearing
Approx. 25 mm
#104
#123
There should be approx. 1-mm clearance
between the guide shaft (#123) and motor
mount (#138).
#506
-
LS-9000
VRA51701-R.3607.A
Approx. 1 mm
#138