General - ADC DSX-3 User Manual

SECTION 3: OPERATION
Content
1

GENERAL......................................................................... 3-1

PROCEDURE 1: CROSS-CONNECT CIRCUIT IDENTIFICATION............................................ 3-2
PROCEDURE 2: DIGITAL OFFICE EQUIPMENT TEST .................................................. 3-3
PROCEDURE 3: IN-SERVICE PATCHING TO BYPASS A FAILED FACILITY .................................... 3-4
PROCEDURE 4: IN-SERVICE ROLL OVER TO NEW FACILITY ............................................ 3-6
PROCEDURE 5: OUT-OF-SERVICE PATCH ........................................................ 3-8
PROCEDURE 6: OUT-OF-SERVICE TRAFFIC PATTERN CHANGES ......................................... 3-9
1 GENERAL
This section presents step-by-step procedures for using the DSX-3 (DSX-4H-24) Rear Cross-
Connect System. Each procedure includes:
• A brief description of the procedure and its purpose.
• A general schematic illustration of the procedure.
• Steps to perform the procedure.
If problems are encountered in performing any of these procedures, contact ADC as described
in Section 5 - General Information.
ADCP-80-314 • Issue 6 • January 2001 • Section 3: Operation
 2001, ADC Telecommunications, Inc.
Page
Page 3-1