General; Office Requirements; Space And Floor Loading - ADC DSX-3 User Manual

Rear cross connect system
Hide thumbs Also See for DSX-3:
Table of Contents

Advertisement

SECTION 2: INSTALLATION
Content
1

GENERAL......................................................................... 2-1

2

OFFICE REQUIREMENTS............................................................... 2-1

2.1
2.2
2.3
2.4
2.5
2.6
3
INSTALLATION ..................................................................... 2-3
3.1
3.2
3.3
3.4
4
POWER APPLICATION AND SYSTEM CHECKOUT.............................................. 2-11
1 GENERAL
This section provides complete instructions for installing the DSX-3 (DSX-4H-24) Rear
Cross-Connect System. It is recommended that the entire section be read and understood
before beginning installation.
If additional installation information is required, refer to DSX-3 (DSX-4H-24) Rear Cross-
Connect Installation Guide, ADCP-80-321.
2 OFFICE REQUIREMENTS

2.1 Space and Floor Loading

The cross-connect system consists of up to 240 circuit modules mounted in a standard 7-foot
× 23-inch (2.13 m × 58.42 cm) unequal flange equipment bay. Maximum width of the bay is
25.94 inches (65.88 cm), and maximum depth is 12 inches (30.47 cm). A fully configured
unwired/uncabled cross-connect system bay weighs approximately 360 pounds (163 kg.)
Space and Floor Loading ........................................................ 2-1
Environment ................................................................. 2-2
Power ..................................................................... 2-2
Signal Levels ................................................................ 2-2
Cable Types ................................................................. 2-2
Cable Lengths ................................................................ 2-2
Bay Installation/Expansion ....................................................... 2-3
Circuit Module Installation ....................................................... 2-4
Installation of Office/Equipment Cabling .............................................. 2-5
Office Power to Bay Wiring ....................................................... 2-8
ADCP-80-314 • Issue 6 • January 2001 • Section 2: Installation
 2001, ADC Telecommunications, Inc.
Page
Page 2-1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dsx-4-24

Table of Contents