ADC DSX-3 User Manual page 29

3.3.2 Cable-to-Bay Termination
Office/equipment cables should be terminated to BNC/TNC connectors at the back of the
DSX-4H circuit modules. A rear view of a DSX-4H chassis with all circuit modules in place is
shown in Figure 2-5.
Terminate each pair of cables from any one office equipment unit to the IN and OUT
connectors on any one circuit module. Terminate the cable carrying signals to the bay (left
side of bay as viewed from front) to the OUT connector and the cable carrying signals away
from the bay to the IN connector. Secure all cables to the cable bar on the rear of the chassis
by use of tie-wraps. Record all equipment terminations on the labels provided on the front of
each module. Record cross-connect terminations on the adhesive-backed designation labels
provided on the back of the chassis.
ADCP-80-314 • Issue 6 • January 2001 • Section 2: Installation
SPACER
OR
FILLER KIT
Figure 2-4. Cable Routing from Bottom to Top
NETWORK
ELEMENT
CABLES
8657-A
Page 2-7
 2001, ADC Telecommunications, Inc.