Connection of an extended extension cable and connector
conversion adapter
FX5S
FX5UJ
This subsection describes the procedures for connecting an extended extension cable and the FX5-CNV-BC to the extension
cable of the FX5 extension module.
B
A
A
A
1
A
1
4
4
E
C
2
G
Connection of an FX3 extension module
FX5S
FX5UJ
The procedure for connecting the FX3 extension module to the bus conversion module is explained below.
A
FX5U
FX5UC
F
3
D
E
FX5U
FX5UC
1.
Separate the case of the connector conversion adapter
into two halves as shown in the figure. To separate the
case, use a precision flathead screwdriver. Slightly
insert the tip of the screwdriver into part A shown in the
figure, and the hook (B in the figure) will come off. (4
points)
2.
Connect the extended extension cable (C in the figure).
3.
Connect the extension cable (D in the figure).
4.
Arrange the tabs (E in the figure) to be outside the case,
align the upper cover (F in the figure) and the lower
cover (G in the figure), and press down the upper cover
until it is hooked.
1.
Connect the extension cable (A in the figure) from the
FX3 extension module to the extension connector of the
bus conversion module.
12.3 Method for Connection of Extension Devices
12
12 INSTALLATION
159