Installing On Din Rail - Mitsubishi Electric MELSEC iQ-F Series User Manual

Installing on DIN rail

A module can be installed on a 35mm wide DIN46277 rail.
Installation
1 1
A
B
C C
3 3
Removal
C
B
3
6 6
D
1 1
A
A
A
5
4
1.
Push out all DIN rail mounting hooks (A in the figure).
2.
Fit the upper edge of the DIN rail mounting groove (B in
the figure) onto the DIN rail.
3.
Lock the DIN rail mounting hooks (C in the figure) while
pressing the module against the DIN rail.
1.
Open the terminal block cover, gradually loosen the left
and right terminal block mounting screws (A in the
figure), and remove the terminal blocks. (The terminal
block of the FX5S CPU module cannot be removed.)
2.
Disconnect the extension cables and the connecting
cables. When removing the extension cable, pull the
pullout tab of the extension cable straight up.
3.
Insert the tip of a flathead screwdriver into the hole of
the DIN rail mounting hook (B in the right figure). This
step also applies for the DIN rail mounting hooks of the
expansion adapters.
4.
Move the flathead screwdriver as shown in the right
figure to draw out the DIN rail mounting hooks of all
devices.
5.
Remove the product from the DIN rail (C in the right
figure).
6.
Push in the DIN rail mounting hooks (D in the figure).
12 INSTALLATION
151
12.2 Installation Methods
12