AJAX Fire Protect User Manual page 7

Setting
First field
Room
Dangerous CO Level Alarm
(FireProtect Plus only)
High temperature alarm
Rapid temperature rise alarm
Alert with a siren if smoke is detected
Alert with a siren if temperature
threshold exceeded
Alert with a siren if rapid temperature
rise detected
Alert with a siren if CO detected
Protect Plus only)
Jeweller Signal Strength Test
Fire Protect Self-Test
User Guide
Un pair Device
Indication
Event
Detector switching on
Detector switching off
Registration failed
Smoke or temperature increase
detected
Battery low
Device name, can be edited
Selecting the virtual room to which the device is assigned
If active, the detector alerts of exceeding the limits of carbon
monoxide concentration
If active, the detector reacts when the temperature is 60°C and
higher
If active, the detector reacts to rapid temperature increase (30°С
for 30 minutes or less)
If active, Home Siren and Street Siren are activated in case of
smoke alarm
If active, Home Siren and Street Siren are activated in case if
temperature threshold exceeded
If active, Home Siren and Street Siren are activated in case if
rapid temperature rise detected
(Fire When turned on, Home Siren and Street Siren are activated in
case if CO concentration is dangerous
Switches the device to the signal strength test mode
Starts Fire Protect self-test
Opens the detector User Guide
Disconnects the sensor from the hub and deletes its settings
The logo lights up green for 1 second
The logo blinks red three times and the device switches off
The logo blinks green for a minute, then the device switches to
the autonomous mode
The siren switches on, the logo lights red during the fire/smoke
alarm
•
One short sound signal per 90 sec — main batteries low (CR2)
Value
Indication