HP Visualize c100 Install Manual page 26

RavenUpgrade.FB 24 Mon Jul 15 11:43:09 1996
Figure 18
NOTICE:
Installing the New Main Tray Assembly
8 Reconnect the power cables and any other cables, or terminators that you discon-
nected when opening the workstation.
9 Connect your monitor's 15-pin connector to the 15-pin connector on the EVC
adapter cable which came with the upgrade kit.
10 Connect the other end of the EVC adapter cable to the built-in video connector
on the rear of the system. Be sure to tighten the thumbscrews on the connectors.
Video Connector
11 Power on the monitor, any peripherals and the system unit.
12 If your keyboard connects to the PS/2 connector on your system, wait 2 seconds
after the Num Lock light flashes near the end of the boot sequence, then press Tab
to initiate the automatic monitor selection process.
It takes approximately one to two minutes after powering on the
workstation before the Num Lock light flashes.
If you have a keyboard that connects to the HIL connector on your system, press
Tab every three seconds during the boot sequence to initiate the automatic mon-
itor selection process.
24
Built-in Video Connector