Cannot Scan The Correct Area On The Scanner Glass; Text Is Not Recognized Correctly When Saving As A Searchable Pdf - Epson WorkForce WF-2880 Series User Manual

Solving Problems
❏ On the Advanced Settings tab in Epson Scan 2, set Descreening.
❏ Change the resolution, and then scan again.
Related Information
"Scanning Using Epson Scan 2" on page 106
&

Cannot Scan the Correct Area on the Scanner Glass

❏ Make sure the original is placed correctly against the alignment marks.
❏ If the edge of the scanned image is missing, move the original slightly away from the edge of the scanner glass.
❏ When placing multiple originals on the scanner glass, make sure there is a gap of at least 20 mm (0.79 in.)
between the originals.
❏ When scanning from the control panel and selecting the auto scan area cropping function, remove any trash or
dirt from the scanner glass and document cover. If there is any trash or dirt around the original, the scanning
range expands to include it.
Related Information
"Placing Originals" on page 48
&
"Cleaning the Scanner Glass" on page 167
&

Text is Not Recognized Correctly when Saving as a Searchable PDF

❏ On the Image Format Options window in Epson Scan 2, check that Text Language is set correctly on the Text
tab.
❏ Check that the original is placed straight.
❏ Use an original with clear text. Text recognition may decline for the following types of originals.
❏ Originals that have been copied a number of times
❏ Originals received by fax (at low resolutions)
❏ Originals on which the letter spacing or line spacing is too small
❏ Originals with ruled lines or underlining over the text
❏ Originals with hand-written text
❏ Originals with creases or wrinkles
❏ In Document Mode in Epson Scan 2, when Image Type on the Main Settings tab is set to Black & White,
adjust Threshold on the Advanced Settings tab. When you increase the Threshold, black becomes stronger.
>
Scanned Image Problems
>
Text is Not Recognized Correctly when Saving as a Searchable PDF
207