Cisco Unified Wireless IP Phone 7925G Quick Reference page 13

Unified wireless ip phone for cisco unified communications manager 7.0
Hide thumbs Also See for Cisco Unified Wireless IP Phone 7925G:
Table of Contents

Advertisement

Use only the Cisco power supply that is compatible with your phone. To order your power
Caution
supply, contact your local dealer and refer to the list of Cisco part numbers.
Australia—CP-PWR-7925G-AU=
Central Europe—
China—CP-PWR-7925G-CN=
Japan—CP-PWR-7925G-JP=
North America—CP-PWR-7925G-NA=
United Kingdom—CP-PWR-7925G-UK=
The battery and power supply are not provided with your phone. To order the battery and
Note
power supply, contact your local dealer.
Power Outage
Your accessibility to emergency service through the phone is dependent on the wireless access point
being powered. If there is an interruption in the power supply, Service and Emergency Calling Service
dialing will not function until power is restored. In the case of a power failure or disruption, you may
need to reset or reconfigure equipment before using the Service or Emergency Calling Service dialing.
Regulatory Domains
The radio frequency (RF) for this phone is configured for a specific regulatory domain. If you use this
phone outside of its regulatory domain, the phone will not function properly, and you might violate
local regulations.
Healthcare Environments
This product is not a medical device and uses an unlicensed frequency band that is susceptible to
interference from other devices or equipment.
Using External Devices
The following information applies when you use external devices with the Cisco Unified Wireless
IP Phone:
Cisco recommends the use of good quality external devices (such as headsets) that are shielded against
unwanted radio frequency (RF) and audio frequency (AF) signals.
Depending on the quality of these devices and their proximity to other devices such as mobile phones
or two-way radios, some audio noise may still occur. In these cases, Cisco recommends that you take
one or more of the following actions:
• Move the external device away from the source of the RF or AF signals.
• Route the external device cables away from the source of the RF or AF signals.
• Use shielded cables for the external device, or use cables with a better shield and connector.
Cisco Unified Wireless IP Phone 7925G for Cisco Unified Communications Manager 7.0
CP-PWR-7925G-CE=
Getting Started
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents