Manual Configuration Of The Buttons - PROEL DBE108E User Manual

• From the "STATUS" window, press "AUTO BUTTON".
With this operation, the base is automatically programmed in a standard way, associating an EVAC unit to
each row of the display following the acquisition order of the various units. 4 buttons are displayed in each
row if the Evac is an AE604, while only one button is displayed if the Evac is an AE300.
The name of the EVAC AE604 / AE300 is shown inside each display button, followed by the number of the
assigned output line and with the name of the zone underneath. Repeat the "AUTO BUTTON" procedure on
other DBE108Es if present.
In the example, 4 buttons are assigned to the AE604-1 for zones 1..4, 1 button for the AE300-1 and 4 other
buttons to the AE604-2.
NOTE
Once the DBE108E bases have been programmed, by disconnecting or reconnecting the bases or the
various Evac units, the acquisition order of the Evac units remains unchanged.

MANUAL CONFIGURATION OF THE BUTTONS

Pressing the "CONFIG" label will open the corresponding page.
By pressing the triangle on the first drop-down menu at the top left, it is possible to select the EVAC unit
whose buttons you want to configure.
12