Bijur Delimon HAP-P Manual

HAP-P Lubricator
Manual, One Shot
General
Lubricator includes a spring return piston pump and is operated by pushing a lever which raises a
piston and compresses a spring, discharging oil into the system. Discharge volume and pressure are
independent of oil viscosity.
Operation
Lubricator includes a spring return piston pump in a plastic reservoir. Pulling up slowly on the lever
handle to the stop fills the cylinder with a predetermined volume of oil. Upon release, spring
pressure discharges the oil into the system and returns the handle to the original position.
Lubricator must be operated at intervals recommended by machine manufacturer.
Technical Data
Reservoir Capacity
Lubricator Inlet Filter
Discharge Pressure
Factory Discharge Setting
Piston Diameter
Piston Stroke Setting
Discharge Volume Per Stroke
Viscosity range
Outlet
Notes Regarding Use
1. Lubricator inlet fi lter should be inspected periodically and cleaned/replaced as required. To
install replacement, disconnect discharge tubing and remove cylinder cap.
2. Discharge pressure will decrease as discharge volume decreases and the number of meter
units in the system increases.
Piston Stroke Setting
Discharge Volume/Stroke (cc)
System & Limitations
Use meter units type F. Total system fl ow (ø) limitation is given in the table below.
Meter Units (#) CC Per Shot
5.0
15 1750
20 1500
25 1230
30 950
40 780
50 640
60 570
70 500
1.
475cc (1 pint)
40 micron particle separation
60 psi average
15cc
1/18"
1/2 to 1-1/8"
5 to 15cc
100 to 10,000 SSU at operating temperature
1/8"NPTF
1-1/8" 13/16"
15 10
7.5 10
2400 2900
1700 2200
1500 1700
1200 1400
960 1100
820 920
710 810
600 720
21/32" 1/2"
7.5 5.0
15
3500
2600
2000
1700
1300
1100
960
860
BIJUR DELIMON INTERNATIONAL
TEL (+44) 01432 365000
WWW.BIJURDELIMON.COM
WWW.BDICOOLING.COM
Denco Lubrication Ltd,
Ramsden Court, Ramsden Road,
Rotherwas Industrial Estate,
Hereford, Herefordshire, HR2 6LR
24375 • R3 04/13