Bijur Delimon HAP-P Manual

HAP-P Lubricator
Manual, One Shot
General
Lubricator includes a spring return piston pump and is operated by pushing a lever which raises a
piston and compresses a spring, discharging oil into the system. Discharge volume and pressure are
independent of oil viscosity.
Operation
Lubricator includes a spring return piston pump in a plastic reservoir. Pulling up slowly on the lever
handle to the stop fi lls the cylinder with a predetermined volume of oil. Upon release, spring pressure
discharges the oil into the system and returns the handle to the original position. Lubricator must be
operated at intervals recommended by machine manufacturer.
Technical Data
Reservoir Capacity
Lubricator Inlet Filter
Discharge Pressure
Factory Discharge Setting
Piston Diameter
Piston Stroke Setting
Discharge Volume Per Stroke
Viscosity range
Outlet
Notes Regarding Use
1. Lubricator inlet fi lter should be inspected periodically and cleaned/replaced as required.
To install replacement, disconnect discharge tubing and remove cylinder cap.
2. Discharge pressure will decrease as discharge volume decreases and the number of meter units
in the system increases.
Piston Stroke Setting
Discharge Volume/Stroke (cc)
System & Limitations
Use meter units type F. Total system fl ow (ø) limitation is given in the table below.
Meter Units (#) CC Per Shot
5.0
15 1750
20 1500
1230
25
30 950
40 780
640
50
60 570
70 500
1
475cc (1 pint)
40 micron particle separation
60 psi average
15cc
1/18"
1/2 to 1-1/8"
5 to 15cc
100 to 10,000 SSU at operating temperature
1/8"NPTF
1-1/8" 13/16"
15 10
7.5
2400
1700
1500
1200
960
820
710
600
21/32" 1/2"
7.5 5.0
10 15
2900 3500
2200 2600
1700 2000
1400 1700
1100 1300
920 1100
810 960
720 860
BIJUR DELIMON INTERNATIONAL
(919) 465 4448 LOCAL
(800) 631 0168 TOLL-FREE
(919) 465 0516 FAX
WWW.BIJURDELIMON.COM
2100 Gateway Centre Blvd., Suite 109
Morrisville, NC 27560
24375 • R3 04/13