Bijur Delimon TM-5 Quick Start Manual

TM-5 Lubricator
Automatic Cyclic
Operation
Lubricator is a motor-driven piston pump spring discharge type. Pump cycle time is controlled by an
integral gear reduction in the motor. Lubricator can be actuated manually by raising and releasing
the instant feed button. Available cycle times are shown in the table below.
Cycle Time
50 Hz
6.4 min
10.6 min
32.0 min
64.0 min
128.0 min
Technical Data
Reservoir Capacity
Lubricator Inlet Filter
Discharge Pressure
Factory Discharge Setting
Discharge Volume Per Cycle*
Viscosity range
Notes Regarding Use
1. Lubricator inlet fi lter should be inspected periodically and cleaned/replaced as required.
2. Discharge pressure will decrease as discharge volume decreases, the number of meter units in
the system increases or oil viscosity decreases.
*Discharge Volume Per Cycle
To reduce oil delivery, remove lock screw, measure "A", turn adjusting screw clockwise, increasing "A"
by "B" dimension, as shown on table below.
B
0.40"
0.32"
0.24"
0.16"
0.08"
0"
1
60 Hz
5.3 min
8.8 min
27.7 min
53.5 min
107.0 min
1 liter (approximately 1 quart)
1 gallon
40 micron particle separation
60 psi maximum
5cc
2.5 to 5cc infi nitely adjustable
150 to 8,000 SSU at operating temperature
Discharge
2.5cc
3.0cc
3.5cc
4.0cc
4.5cc
5.0cc
Note: Conversion kits for Crouzet motors
are available – request part #26600.
BIJUR DELIMON INTERNATIONAL
(919) 465 4448 LOCAL
(800) 631 0168 TOLL-FREE
(919) 465 0516 FAX
WWW.BIJURDELIMON.COM
2100 Gateway Centre Blvd., Suite 109
Morrisville, NC 27560
21836 • R3 05/12