Cisco 7935 System Manual page 18

Phone Button Templates
Table 40-3 Phone Button Feature Description (continued)
Feature
Conference
Forward all
Hold
Line
Meet-Me conference
Message waiting
None
Cisco CallManager System Guide
40-18
Description
Users can initiate an ad hoc conference and add
participants by pressing the Conference button. (Users
can also use the Join softkey to initiate an ad hoc
conference.)
Only the person who initiates an ad hoc conference
needs a conference button. You must make sure that an
ad hoc conference bridge device is configured in
Cisco CallManager Administration for this button to
work. See Conference Bridges
Users press this button to forward all calls to the
designated directory number. Users can designate
forward all in the Cisco IP Phone Configuration
windows, or you can designate a forward all number for
each user in Cisco CallManager Administration.
Users press this button to place an active call on hold. To
retrieve a call on hold, users press the flashing line
button or lift the handset and press the flashing line
button for the call on hold. The caller on hold receives a
tone every 10 seconds to indicate the hold status or
music (if the Music On Hold feature is configured). The
hold tone feature requires no configuration to work.
Users press this button to dial a number or to answer an
incoming call. You must have added directory numbers
on the user phone for this button to work.
When users press this button, they initiate a meet-me
conference, and they expect other invited users to dial in
to the conference. Only the person who initiates a
meet-me conference needs a meet-me button. You must
make sure that a meet-me conference device is
configured in Cisco CallManager Administration for
this button to work.
Users press this button to connect to the
voice-messaging system.
Use None to leave a button unassigned.
Chapter 40 Cisco IP Phones
for more information.
OL-7135-01