Enabling Or Disabling Cdrs - Cisco 30 VIP Troubleshooting Manual

For cisco callmanager release 3.0(1)

Hide thumbs Also See for 30 VIP:

Table of Contents

Cisco IP Telephony Troubleshooting Guide for Cisco CallManager Release 3.0(1)

List of fields contained in each record and a description of what that field represents

Description of the types of calls logged, and the fields logged with each of them

List of cause codes that may appear in the CDR records

Enabling or Disabling CDRs

CDR record creation is disabled by default when the system is installed. If you wish to have

CDR data, you must enable CDRs in the Service > Service Parameters area of

Cisco CallManager Administration. CDR processing can be enabled and disabled at any time

while the system is in operation. You do not need to restart Cisco CallManager for the enabling

or disabling of CDRs to take effect. The system will respond to all changes within a few seconds.

CMR or diagnostic data is enabled separately from CDR data. CMR data will not be generated

unless both CDRs and Call Diagnostics are enabled, but CDR data may be generated and logged

without CMR data.

Use the following steps to enable CDRs.

1. Open Cisco CallManager Administration.

2. Select Service > Service Parameters.

3. Select the IP address of your Cisco CallManager installation.

4. From the list of Parameters, select CDREnabled.

5. Define type as boolean.

6. Select T for True.

Table of Contents