Disk Space Warning - Cisco 30 VIP Troubleshooting Manual

Cisco IP Telephony Troubleshooting Guide for Cisco CallManager Release 3.0(1)
SdlTraceTypeFlags Definitions
SDLTraceTypeFlag
traceLayer1
TraceDetailLayer1
TraceSdlLinkAdmin
traceUnused
traceLayer2
traceLayer2Interface
traceLayer2TCP
TraceDetailLayer2
traceLayer3
traceCc
traceMiscPolls
traceMisc
traceMsgtrans
traceUuie
traceGateway
Data bits described in the following table are set in the Service > Service Parameters area in
Cisco CallManager Administration. Following are two examples of desired values based on the
particular problem.
The recommended value for normal system debugging is SdlTraceDataFlags=0x110
The recommended value when tracking problems with SDL links is 0x13D (non-
compacted trace; if a compact trace is desired, bit 0x200 must be set. It can be set in
combination with any other bits)
SDLTraceDataFlags Definitions
SDLTraceDataFlag
TraceSdlLinkState
TraceSdlLowLevel
TraceSdlLinkPoll
TraceSdlLinkMsg
traceRawData
TraceSdlTagMap
traceCreate
TraceNoPrettyPrint

Disk Space Warning

IMPORTANT: Be advised that information obtained from this interface could be very detailed,
and therefore consume a large amount of disk space. For this reason, we advise you to turn on
the trace file for a specific amount of time, then review the information and turn off the trace.
© 2000 Cisco Systems, Inc.
Value Definition
= 0x00000001 All Layer 1 trace on
= 0x00000002 Detail Layer 1 trace on
= 0x00000004 Trace inter-Cisco CallManager links within a cluster
= 0x00000008 Not used
= 0x00000010 All Layer 2 trace on
= 0x00000020 Layer 2 interface trace on
= 0x00000040 Layer 2 TCP trace on
= 0x00000080 More detail dump of Layer 2 Frames.
= 0x00000100 All Layer 3 trace on
= 0x00000200 All call control trace on
= 0x00000400 Trace miscellaneous polls
= 0x00000800 Miscellaneous trace on (Database signals)
= 0x00001000 Message Translation signals (TranslateIsdnToSdlReq,
TranslateIsdnToSdlRes TranslateSdlToIsdnReq,
TranslateSdlToIsdnRes)
= 0x00002000 UUIE output trace on
= 0x00004000 Gateway signals
Value Definition
= 0x001 Enable trace of SDL Link Initialization
= 0x002 Enable tracing of low-level SDL events, for example, fileOpen,
socket events, and so on
= 0x004 Enable tracing of SDL Link Poll message
= 0x008 Enable tracing of SDL Link Message
= 0x010 Enable raw signal data trace on all signals
= 0x020 Enable tag mapping
= 0x100 Enable process create and stop traces
= 0x200 Disable pretty printing of trace files
17