Table of Contents
Advertisement
DESIGN GUIDE
Zones
Configuring Zones
By default, zones come pre-configured for Stereo usage . However with an ELAN IP Amp chassis, the zones
can be configured in a multitude of ways . A zone can consist of a single output (speaker or pre-amp) or multiple
outputs (speaker, preamp or any combination of the two) .
By allowing this level of customization, the ELAN IP Amp can truly be configured in a way that optimizes your
audio project .
This means that the amount of zones per chassis is dependent on the zone configuration . For example, an EL-
IPD-MTX-8CH can have each output set up as an independent zone . The eight speaker outputs (which are 4
ohm stable and able to handle summed-stereo) and four pre-outs add up to 12 independent zones versus the
default of six zones (four pairs of speaker outputs and two pairs of pre-outputs) .
NOTE: all zones outputs must be contained to a single chassis and can not be across multiple chassis .
To configure the zones, begin by navigating to the Chassis, Zones and then Configuration:
Output & Device (in Multi-Chassis)
This is read only information that indicates which chassis and which output(s) are being configured . You can
select multiple rows to configure multiple outputs of the same zone by using Shift/Ctrl .
20
Advertisement
Table of Contents
