Advertisement
Quick Links
Advertisement
Related Manuals for WATSON C9 Rail
Summary of Contents for WATSON C9 Rail
- Page 1 ASSEMBLY C9 Rail 360.394.1300 watsonfurniture.com V.20.0 04/2020...
- Page 2 WARNING - No more than 12 duplex receptacles shall be supplied by one circuit. (12 segments Two Duplex, 6 segments Four Duplex) WARNING - For commercial use only. NOTE - Installation must be in accordance with the National Electrical Code and local codes. Electrically interconnected tables need to be mechanically connected. The C9 Rail is ETL listed to UL962...
- Page 3 C9 Rail Basic Components Rail Segment End Leg Floor Anchor Bracket Bender Cap Bender Leg Modesty Panel End Cap Power Harness C9 RAIL ASSEMBLY INSTRUCTIONS...
- Page 4 Phillips Drill/Driver 2mm Hex Drill/ 3mm Hex Drill/ Driver Bit Driver Bit Additional tools such as a 90 Degree Bit and an 18” Extension are helpful for some steps *No torque or ball bits should be used C9 RAIL ASSEMBLY INSTRUCTIONS...
- Page 5 You will repeat this step for the end- of-run rail segment as well. M6-1.0x12mm Low Plastic Reusable *Please note: a 90 degree Profile Cap Screw Push Rivet bit is helpful for this step. (0001140) (0000822) C9 RAIL ASSEMBLY INSTRUCTIONS...
- Page 6 After installing the bender caps, slide the rails onto the bender leg assembly. The openings in the bender caps at the end of each rail segment should fit snugly around the bender leg assembly brackets. The example below shows two end rail segments connected. C9 RAIL ASSEMBLY INSTRUCTIONS...
- Page 7 The bender leg must be straight at the time of routing the jumper through. Once in place, use 2 (0001247) screws to secure the harness in place through the bottom of the rail. M6-1.0x100mm Button Head Cap Screw (0001247) C9 RAIL ASSEMBLY INSTRUCTIONS...
- Page 8 Only one ground wire is needed per jumper. 8/32x1/4 Thread Cutting Screw (121405) Bending the Rail Once the run is assembled, and power/data is installed, bend the rails to the desired angles. The bender legs can bend 90 degrees in either direction. C9 RAIL ASSEMBLY INSTRUCTIONS...
- Page 9 After accessories are installed, mount drain tray back in place with the set aside hardware. C9 RAIL ASSEMBLY INSTRUCTIONS...
- Page 10 Secure Side Panels Mount side panels in place using one screw (121538) for each side of panel, (4) screws total. Hold down the opposite side panel for direct drill access. 8-32x1/4” Thread Cutting Screw (121538) C9 RAIL ASSEMBLY INSTRUCTIONS...
- Page 11 Floor Mount (for single segments) In the case of only a single segment being used, the segment must be mounted to the floor using the supplied floor anchor bracket and 4 floor anchor screws (480136) per foot. C9 RAIL ASSEMBLY INSTRUCTIONS...
-
Page 12: Wiring Schematic
RISK OF FIRE OR ELECTRIC SHOCK. THIS OFFICE FURNISHING SYSTEM MAY BE CONNECTED TO MORE THAN ONE SOURCE OF SUPPLY. ALL SOURCES MUST BE DISCONNECTED PRIOR TO ANY SERVICING. NO SINGLE CIRCUIT MAY BE POWERED BY MORE THAN ONE SOURCE. C9 RAIL ASSEMBLY INSTRUCTIONS...