Table of Contents
Advertisement
®
R&S
NRQ6
Color
State
Green
The power sensor is correctly connected to the network.
It has been assigned a valid IP address, either manually or via DHCP.
Red
The power sensor is not connected to the network correctly.
Either the connection is erroneous or the sensor has not been assigned a valid
IP address yet.
PoE+ status LED
See (2) in
Figure
Shows whether the R&S NRQ6 is correctly powered over PoE+ or not.
Color
State
Green
The sensor is powered over PoE+. You can operate it using the Ethernet inter-
face.
No light
No PoE+ power is present.
LAN reset button
See (3) in
Figure
Resets the Ethernet connection parameters of the power sensor to their default
values.
After a LAN reset, the Ethernet interface is set DHCP mode where automatic
address allocation is attempted.
4.4
Host interface
See (4) in
Figure
The 8-pole male sensor connector (M12) is used to connect the R&S NRQ6 to a
computer or an R&S NRX base unit.
Further information:
●
Chapter 3.6.1, "Computer using a LAN
●
Chapter 3.6.2, "Computer using a USB
●
Chapter 3.6.3, "R&S NRX base
Getting Started 1178.3705.02 ─ 08
4-2.
4-2.
4-1.
connection",
connection",
unit",
on page 28
R&S NRQ6 tour
Host interface
on page 19
on page 25
34
Advertisement
Table of Contents
