HP Net PC 20 Supplementary Manual page 22

Installing a Slim Floppy Disk Drive
5 Slide the floppy disk drive (connected to its tray) into the front panel chassis
and secure the drive in position using the 3 screws supplied with it.
4 hooks (2 on either side) to connect the floppy
disk drive tray to the front panel chassis
Front panel chassis
Front of front
panel chassis
6 If you removed the front bezel earlier, clip it back into position now.
7 Connect one end of the floppy disk drive cable to the floppy disk drive.
8 Place the front panel chassis slightly in front of the main chassis.
9 Carefully connect the other end of the floppy disk drive cable to the FDD
connector on the system board (refer to "System Board and Backplane" on
page 12).
10 Replace the front panel chassis (refer to "Replacing the Front Panel Chassis"
on page 17).
11 Replace the cover (refer to "Replacing the Cover" on page 15).
22
2 screws to secure the floppy disk drive
tray to the top of the front panel chassis
1 screw to secure the floppy
disk drive tray to the CD-ROM
drive tray
Floppy disk drive
and tray
Slim CD-ROM drive
Hard disk drive