Installing A Slim Cd-Rom Drive - HP Net PC 20 Supplementary Manual

Installing a Slim CD-ROM Drive

To install a Slim CD-ROM drive, take the following steps.
1 Remove the cover (refer to "Removing the Cover" on page 14).
2 Remove the front panel chassis (refer to "Removing the Front Panel Chassis"
on page 16).
3 Attach the L-shaped metal bracket by matching the two screw holes of the
metal bracket with the first and last screw holes of the group of four screw
holes on the right underside portion of the CD-ROM drive and securing the two
screws to it.
L-shaped metal
bracket
4 If this is the first time that a CD-ROM is being installed in the PC, remove the
front panel plastic cover from the CD-ROM drive bay by pushing outwards
from the inside with your fingers.
5 Slide the new CD-ROM drive onto the CD-ROM drive shelf and, using the
screws provided with the drive, secure the drive in position.
6 Attach the CD-ROM drive adaptor to the CD-ROM drive adaptor connector
located at the back of the CD-ROM drive by:
a first securing the copper hexagonal bolt to the rear of the CD-ROM drive by
hand, and
b securing the two mini-screws from the CD-ROM drive adaptor into the cop-
per hexagonal bolt with a mini-screwdriver.
First and last screw hole on the right
underside portion of the CD-ROM drive
Installing a Slim CD-ROM Drive
19