HP Kayak XU04 Supplementary Manual page 44

LCD Error Messages
No CPU 1
CPU Socket
Rebuild Your PC
Workstation's
Components
2 Troubleshooting Your HP PC Workstation
If Your PC Workstation Does Not Start Properly
Check that boot processor is correctly
installed in socket 1.
Check that either a processor or
terminator is installed in the processor
slot.
4 Replace the cover.
5 Reconnect all cables and power cords.
6 Turn on the display and computer.
If your PC Workstation still does not start properly, remove all boards
and accessories, except the hard disk drive and video board. Start the
PC Workstation. If the PC Workstation now works, add the boards and
accessories one at a time to determine which one is causing the
problem.
If you are Unable to Change any Values in Setup
Ensure that you are using the correct password.
If a POST Error Message is Displayed
The Power-On-System-Test (POST) can detect both an error and a
change to the configuration. In either case, an error code and short
description is displayed. Depending on the kind of error, you will have
one or more of these choices available on screen:
Press to ignore the message and continue.
•
Press to run Setup and correct a system configuration error. HP
•
recommends that you correct the error before proceeding, even if
the PC Workstation appears to start successfully.
Press to accept (validate) the change and update Setup's
•
configuration information.
36 English
Action
Refer to "Installing a Processor" on page
22.
Reference