HP Kayak XU04 Supplementary Manual page 32

Completing the
Installation of a
Processor
NOTE
Your PC Workstation's
system board switches
may look like either of the
examples documented
here.
1 How to Install Accessories In Your HP PC Workstation
Installing a Processor
7 Replace the metal retaining plate.
8 Replace the HP UltraFlow airflow guide (refer to page 5).
1 Verify that the system board bus speed switches are correctly
configured for the processor.
If two processors are installed, both must operate at the same bus and
processor speed.
Refer to the manual supplied with the processor to verify which bus and
processor speeds are supported.
UP=OFF
DOWN=ON
Switch 2 Switch 3
OFF ON
OFF ON
OFF ON
2 Install any other accessories before completing the installation of the
processor.
24 English
Switch 4 Switch 5
OFF OFF
OFF ON
ON OFF
OPEN=OFF
CLOSED=ON
External Processor
Bus Speed Speed
100 MHz 400 MHz
100 MHz 450 MHz
100 MHz 500 MHz