HP Kayak XU04 Supplementary Manual page 23

NOTE
Before Installing an
IDE Device
Before Installing a
SCSI Device
3 If an error message appears, follow the instructions provided by the
Error Message Utility. When prompted, press
program.
4 Select the
Advanced
item, check that the details for the device have been
Primary Master
correctly detected by the Setup program.
5 Press to save and exit Setup.
Refer to the operating system documentation for information on
formatting a drive.
If an IDE drive is removed, the system BIOS will automatically detect
that the device is missing. Press
the device. The system configuration will be updated automatically.
Installing a Drive in a Front-Access Shelf
These instructions explain how to install a drive (such as a flexible disk
drive, a CD-ROM drive, CD-RW drive, or a tape drive) in one of the
front-access drive shelves. You should also refer to the manual supplied
with the drive for any additional installation instructions.
Refer to the drive's installation guide to see if you must set jumpers or if
there is a special installation procedure to follow.
If you are installing a SCSI device, refer to the section "Before Installing
a SCSI Hard Disk" on page 9 before using the following instructions.
1 Disconnect the computer's power cord and any LAN or
telecommunications cable.
2 Remove the computer's cover (see page 3).
1 How to Install Accessories In Your HP PC Workstation
menu, and the
IDE Devices
to confirm that you want to remove
Installing Mass Storage Devices
to run the Setup
submenu. In the
IDE
English 15