HP Kayak XU04 Supplementary Manual page 15

NOTE
Insert the memory module into the
slot at 90º to the system board
Push the module until the
retaining clips click into position.
To ease installation, place your PC Workstation on its side with the
system board facing upwards.
6 Insert the memory module into the slot at 90º to the system board
(with the cutouts furthest from the processor).
7 Firmly press the memory module completely into the connector
until the retaining clips click into position.
8 Repeat this procedure for each additional memory module you want
to install.
9 Install any other accessories if necessary, then replace all units and
reconnect all cables and power cords. Replace the cover (refer
to page 4) and the airflow guide (refer to page 5).
10 Check the HP Summary Screen to verify the new configuration (for
more information refer to "The HP Summary Screen and Setup
Program" on page 60).
1 How to Install Accessories In Your HP PC Workstation
Installing Memory
Memory module
cutouts
English 7