HP Kayak XU04 Installation Manual page 23

Completing the
Installation of a
Processor
NOTE
Your PC Workstation's
system board switches
may look like either of the
examples documented
here.
NOTE
HP Kayak XU PC Workstation — Installing Accessories In Your HP PC Workstation
1 Verify that the system board bus speed switches are correctly
configured for the processor.
If two processors are installed, both must operate at the same bus and
processor speed.
Refer to the manual supplied with the processor to verify which bus and
processor speeds are supported.
UP=OFF
DOWN=ON
Switch 2 Switch 3
OFF ON
OFF ON
OFF ON
2 Install any other accessories before completing the installation of
the processor.
3 Replace the cover (see page 4).
4 Turn on the computer and check that the new processor is
recognized by the power-on system-test.
To fully benefit from dual processing, you will need to re-install
Windows NT 4.0 on your PC Workstation.
Switch 4 Switch 5
OFF OFF
OFF ON
ON OFF
Installing a Processor
OPEN=OFF
CLOSED=ON
External Bus Processor
Speed Speed
100 MHz 400 MHz
100 MHz 450 MHz
100 MHz 500 MHz
English
23