HP Kayak XM600 User Manual page 39

Before Installing an
IDE Hard Disk
Primary IDE cable supports two
Hard Disk Drives
Primary IDE Connector
To identify the positions of other system board connectors, refer to the label located on
the inside of the cover.
• The ATA IDE cable supports two IDE devices. This cable is connected
to the Primary IDE connector on the system board. The bootable hard
disk drive is connected to this cable via the MASTER connector. A
second hard disk drive could be installed by using the SLAVE connector.
• A second IDE drive cable supports two IDE devices. If you install a
CD-ROM drive, a DVD drive or a Zip drive, connect it to this cable.
• The third cable has one connector for a floppy drive.
Refer to the drive's installation guide to check jumper settings or if there is
a special installation procedure to follow.
HP Kayak XM600 Cables and Connectors
Secondary IDE Connector
2 Installing and Replacing Hardware Parts in Your PC Workstation
Installing Mass Storage Devices
Two IDE data cables each with
two 40-pin connectors for IDE
Drives
Secondary IDE cable for access
devices such as CD-ROM Drives
or Zip Drives
Cable with one 34-pin
connector for 3.5-inch Floppy
Disk Drive
Floppy Disk Drive Connector
39