Replacing The Floppy Disk Drive - HP Kayak XM600 User Manual

2 Installing and Replacing Hardware Parts in Your PC Workstation

Replacing the Floppy Disk Drive

Removing the
Floppy Disk Drive
Installing the Floppy
Disk Drive
Replacing the Floppy Disk Drive
1 Switch off the display and PC Workstation. Disconnect all power cables
and any LAN or telecommunications cables.
2 Remove the PC Workstation's cover and front upper bezel (refer to page
23 for these instructions).
3 Disconnect the power and data cables from the old drive.
4 Place one hand at the rear of the drive.
5 To release the drive, press the two locking clips located at the front of
the drive inwards. From the back of the drive gently push forward to
remove it from the shelf.
6 Remove the two short green guide rails by gently prying them off the
drive. These guide rails will be required for the new drive.
ê
1 Add the short green guide rails to the new drive. Insert the guide rail
labeled "L" on the left-hand side (cable connectors facing towards you
and positioned at the top), and the guide rail "R" on the right-hand side
of the hard disk drive.
2 Align the guide rails on both sides of the drive with the internal shelf
guides, then slide the drive until it clicks into position.
3 Connect the power and data cables to the new drive and any installed
drives. The connectors are shaped to go in one way only.
4 Replace the front bezel and PC Workstation's cover (refer to page 24).
Reconnect all the power and telecommunications cables.
5 Turn to page 49 to complete the installation.
48