Removing And Replacing A Pci Accessory Card - HP Kayak XM600 User Manual

2 Installing and Replacing Hardware Parts in Your PC Workstation

Removing and Replacing a PCI Accessory Card

NOTE
Removing and Replacing a PCI Accessory Card
To remove or install an accessory card, complete the following steps:
1 Switch off the display and PC Workstation. Disconnect all power cables
and any LAN or telecommunications cables.
2 Remove the PC Workstation's cover (refer to page 23 for instructions).
3 If you intend to:
a Install an Accessory Card:
Unscrew and remove the slot panel. Store it in a safe place. If the slot
cover is tight, loosen the screws on the adjacent slots.
b Replace an Accessory Card:
Remove any cables connected to the accessory card. Remove the
screw that holds the old card in place and carefully pull it out.
Some cards may have preferred locations and special installation
instructions detailed in their manuals.
4 Aligning the new card carefully, slide it into position, then press it firmly
into the slot and tighten the retaining screw.
5 Install any other accessories before replacing the cover (refer to page
24). Reconnect all cables and power cords.
HP Kayak XM600 Upgrades
The HP Kayak XM600 has five 32-bit 33 MHz, 5 V PCI accessory card slots
and one Universal AGP PRO slot on the system board.
HP Kayak XU800 Upgrades
There are five PCI accessory card slots:
• Three 32-bit 33 MHz PCI slots 1, 2 and 5.
• Two 64-bit 66 MHz PCI slots 3 and 4.
The three 32-bit/33 MHz PCI slots accept 5 V PCI cards and Universal PCI
cards (support for 3.3 V or 5 V), while the two 64-bit/66 MHz PCI slots
supports 3.3 V PCI cards and Universal PCI cards (support for 3.3 V or 5 V).
A universal compatible 32-bit 33 MHz accessory card can be installed in PCI
slot 3 and 4, however both slots will only perform at 33 MHz.
36