Replacing The Processor Fan - HP Kayak XM600 User Manual

Removing the
Processor Fan
Replacing the
Processor Fan
NOTE

Replacing the Processor Fan

1 Switch off the display and PC Workstation. Disconnect all power cables
and any LAN or telecommunications cables.
2 Remove the PC Workstation's cover (refer to page 22 for instructions).
3 Remove the HP UltraFlow Airflow Guide (refer to page 24).
4 From the rear of the PC, use a screwdriver to gently push the two
retaining clips inwards, then lift the processor fan up and out of chassis.
5 Disconnect the processor fan cable from the "PWR_FAN" connector on
the system board.
1 Connect the processor fan cable to the "PWR_FAN" connector on the
system board. Place the cable between the power supply unit and
processor.
Ensure that the "Intrusion Switch" is clear of the processor fan.
2 The processor fan can only be installed in one way. The distance
between the two retaining clips is shorter at the top than the bottom.
Align the new processor fan clips with their corresponding sockets.
3 Gently push the processor fan towards the front of the chassis, then
downwards until it clicks into place.
4 Replace the HP UltraFlow Airflow Guide (refer to page 24).
5 Replace the PC Workstation's cover (refer to page 23). Reconnect all the
power and telecommunications cables.
2 Installing and Replacing Hardware Parts in Your PC Workstation
Replacing the Processor Fan
45