HP Kayak XM600 User Manual page 48

2 Installing and Replacing Hardware Parts in Your PC Workstation
Replacing the System Board
Installing the New
System Board
å
NOTE
1 Clip the retaining bracket onto the new system board.
2 Lower the system board onto the guide pins ensuring that all hooks are
correctly positioned. Check that the rear connectors are aligned
correctly with their sockets.
3 Replace the screw to secure the system board in place.
4 Slide the front access cage back into position (described on page 38).
5 Reconnect any cables you disconnected earlier from the system board.
6 Replace the main memory, processor and any accessory cards in the new
system board (described in this chapter).
7 Replace the HP UltraFlow Airflow Guide (refer to page 24).
8 Replace the PC Workstation's cover and front bezel (refer to page 23).
Reconnect all the power and telecommunications cables.
9 After installing the system board, you need to update your BIOS.
The latest BIOS for your PC and instructions on updating the BIOS are
available from: www.hp.com/go/kayaksupport.
48

ê