HP Kayak XM600 User Manual page 38

2 Installing and Replacing Hardware Parts in Your PC Workstation
Installing an Accessory in the Front Access Cage
NOTE
10 Put the front access cage back into the PC. The front access cage
retainers should be aligned with the chassis.
11 Connect the power and data cables to the installed devices. For
convenience, it is recommended to start from the bottom and work
upwards. The connectors are shaped to go in one way only. If you are
not sure which connector to use, refer to "Installing Mass Storage
Devices", on page 32.
12 Ensure that the two metal guides on the inside of the chassis on the
right-hand side are aligned with the two front access cage retainers.
Slide the front access cage towards the rear of the PC until it snaps into
place.
To verify that the front access cage is correctly in position, check that the
"Align "mark on top of the chassis is parallel with the one on top of the
chassis edge.
13 Secure the front access cage in position using the retaining screw you
removed earlier.
14 To allow access to the device, remove the plastic plate from the cover by
unclipping it on one side and pivoting it out. Store the plate in a safe
place.
15 Replace the HP UltraFlow Airflow Guide (refer to page 24).
38