Replacing The Floppy Disk Drive - HP Kayak XM600 User Manual

2 Installing and Replacing Hardware Parts in Your PC Workstation

Replacing the Floppy Disk Drive

CAUTION
Removing the
Floppy Disk Drive
Installing the Floppy
Disk Drive
Replacing the Floppy Disk Drive
Be very careful not to hurt your fingers when you remove and replace
the drive tray holder.
1 Switch off the display and PC Workstation. Disconnect all power cables
and any LAN or telecommunications cables.
2 Remove the PC Workstation's cover and front bezel (refer to page 23 for
these instructions).
3 Refer to page 37 for instructions on removing the front access cage.
4 Remove the screws (one yellow, one black) on the side of the drive tray
and remove the old drive.
5 Remove the screws from the drive tray holder.
black screw
1 Secure the floppy disk drive to the drive tray holder
2 Slide the new drive into the drive tray (with the correct orientation) and
tighten the screws.
3 Put the front access cage back into the PC. The front access cage
retainers should be aligned with the chassis.
4 Connect the power and data cables to the new drive and any installed
drives. The connectors are shaped to go in one way only. If you are
not sure which connector to use, refer to "Installing Mass Storage
Devices", on page 32.
5 Ensure that the two metal guides on the inside of the chassis on the
right-hand side are aligned with the two front access cage retainers.
Slide the front access cage towards the rear of the PC until it snaps into
place.
40
yellow screw